Make this hose2420R349D068
Finished length680 mm
Hose specification6I
Quantity1
Left fitting1/4 0°（手写接头规格）FITTING · 0°View real fitting photos ↗
Right fitting1/4 0°（手写接头规格）FITTING · 0°View real fitting photos ↗
Route分配阀左内—电磁阀
Individual hose record
2420R349D068 Hose Repair Specifications
Excavator · Kobelco · SK460-8 · 控制阀系统
Finished length680 mm
Hose repair card
Everything needed to identify and make this hose
Kobelco SK460-8Part 2420R349D068
Tap the card to enlarge it without leaving this page.
Repair specifications
- Part number
- 2420R349D068
- Installation route
- 分配阀左内—电磁阀
- Hose specification
- 6I
- Finished length
- 680 mm
- Left fitting
- 1/4 0°（手写接头规格）
- Right fitting
- 1/4 0°（手写接头规格）
- Quantity
- 1
Workshop guide
Finding the correct hydraulic hose for Kobelco SK460-8 控制阀系统
Start with the machine and route
For Kobelco SK460-8 控制阀系统, identify the exact model and hydraulic system on the machine first. A part number or diagram pipe number is the fastest way to narrow a replacement hose; if neither is visible, compare the installation route and the existing hose.
Read the dimensions before cutting
Check whether a listed dimension is finished assembly length, hose-only length, or cut length. These are not interchangeable. Confirm hose specification and pressure rating, then compare both ends separately: thread, sealing seat, size, angle, and orientation.
Records to compare
- 2420R349D068680 mm · 6I · 分配阀左内—电磁阀
Use the drawing as a location check
Where an installation drawing or manual figure is available, match its callout to the part number and physical route. A hydraulic circuit diagram explains connections but does not show the exact routing of a hose on the machine. Take the old hose or clear end-fitting photographs to the workshop if any dimension is missing.
For reference only. Confirm the actual hose before fabrication.