- Length
- 2,004 mm
- Specification
- DN10;2SN-6;33Mpa
- Left fitting
- 90° elbow, American female thread, flat-face sealOriginal Chinese: 90°美制内螺纹平面密封
- Right fitting
- 90° elbow, American female thread, flat-face sealOriginal Chinese: 90°美制内螺纹平面密封
Individual hose record
8U-0124 Hose Repair Specifications
Excavator · Caterpillar · CAT®214B FT · Hydraulic Tank
Finished length2,210 mm
Repair specifications
- Part number
- 8U-0124
- Diagram pipe number
- 24
- Installation route
- 液压油过滤器~过渡阀块(连接液压油过滤器)
- Hose specification
- DN8;-5;17.5Mpa
- Finished length
- 2,210 mm
- Working pressure
- 17.5 MPa
- Left fitting
- 90° elbow, American female thread, flat-face sealOriginal Chinese: 90°美制内螺纹平面密封
- Right fitting
- 90° elbow, American female thread, flat-face sealOriginal Chinese: 90°美制内螺纹平面密封
- Quantity
- 1
Same system
Related Hoses
- Length
- 531 mm
- Specification
- DN25;2SN-16;16.5Mpa
- Left fitting
- American female thread, flat-face sealOriginal Chinese: 美制内螺纹平面密封
- Right fitting
- 90° elbow, American female thread, flat-face sealOriginal Chinese: 90°美制内螺纹平面密封
Workshop guide
Finding the correct hydraulic hose for Caterpillar CAT®214B FT Hydraulic Tank
Start with the machine and route
For Caterpillar CAT®214B FT Hydraulic Tank, identify the exact model and hydraulic system on the machine first. A part number or diagram pipe number is the fastest way to narrow a replacement hose; if neither is visible, compare the installation route and the existing hose.
Read the dimensions before cutting
Check whether a listed dimension is finished assembly length, hose-only length, or cut length. These are not interchangeable. Confirm hose specification and pressure rating, then compare both ends separately: thread, sealing seat, size, angle, and orientation.
Records to compare
- 8U-01242,210 mm · DN8;-5;17.5Mpa · 液压油过滤器~过渡阀块(连接液压油过滤器)
Use the drawing as a location check
Where an installation drawing or manual figure is available, match its callout to the part number and physical route. A hydraulic circuit diagram explains connections but does not show the exact routing of a hose on the machine. Take the old hose or clear end-fitting photographs to the workshop if any dimension is missing.
For reference only. Confirm the actual hose before fabrication.