Make this hose266-1098
Finished length1,700 mm
Hose specification10IV
Quantity1
Left fitting11/16″ 0°（手写接头规格）FITTING · 0°View real fitting photos ↗
Right fitting11/16″ 0°（手写接头规格）FITTING · 0°View real fitting photos ↗
Route液压泵左调节器—分配阀上边左边（高压）
Individual hose record
266-1098 Hose Repair Specifications
Excavator · Caterpillar · CAT®323D L · Hydraulic Pump
Finished length1,700 mm
Hose repair card
Everything needed to identify and make this hose
Caterpillar CAT®323D LPart 266-1098
Tap the card to enlarge it without leaving this page.
Repair specifications
- Part number
- 266-1098
- Installation route
- 液压泵左调节器—分配阀上边左边（高压）
- Hose specification
- 10IV
- Finished length
- 1,700 mm
- Left fitting
- 11/16″ 0°（手写接头规格）
- Right fitting
- 11/16″ 0°（手写接头规格）
- Quantity
- 1
Same system
Related Hoses
- Length
- 1,420 mm
- Specification
- 25IV
- Left fitting
- F47.6 90°（手写接头规格）
- Right fitting
- F47.6 90° H130（手写接头规格）
Workshop guide
Finding the correct hydraulic hose for Caterpillar CAT®323D L Hydraulic Pump
Start with the machine and route
For Caterpillar CAT®323D L Hydraulic Pump, identify the exact model and hydraulic system on the machine first. A part number or diagram pipe number is the fastest way to narrow a replacement hose; if neither is visible, compare the installation route and the existing hose.
Read the dimensions before cutting
Check whether a listed dimension is finished assembly length, hose-only length, or cut length. These are not interchangeable. Confirm hose specification and pressure rating, then compare both ends separately: thread, sealing seat, size, angle, and orientation.
Records to compare
- 266-10981,700 mm · 10IV · 液压泵左调节器—分配阀上边左边（高压）
Use the drawing as a location check
Where an installation drawing or manual figure is available, match its callout to the part number and physical route. A hydraulic circuit diagram explains connections but does not show the exact routing of a hose on the machine. Take the old hose or clear end-fitting photographs to the workshop if any dimension is missing.
For reference only. Confirm the actual hose before fabrication.