- Length
- 450 mm
- Specification
- DN19;4SH-12;42MPa
- Left fitting
- 90° light-series flangeOriginal Chinese: 90°法兰-轻型
- Right fitting
- 90° light-series flangeOriginal Chinese: 90°法兰-轻型
Individual hose record
2184-1036D43 Hose Repair Specifications
Excavator · Doosan · DX225LCA · Swing Motor
Finished length550 mm
Repair specifications
- Part number
- 2184-1036D43
- Diagram pipe number
- 1K
- Installation route
- 回转马达 · SWING MOTOR · Fig. 1190 · 管号 1K
- Hose specification
- DN13;1SN-08;16MPa
- Finished length
- 550 mm
- Working pressure
- 16 MPa
- Left fitting
- British female thread, 60° external cone seatOriginal Chinese: 英制内螺纹60°外锥
- Right fitting
- 90° elbow, British female thread, 60° external cone seatOriginal Chinese: 90°英制内螺纹60°外锥
Same system
Related Hoses
- Length
- 660 mm
- Specification
- DN19;4SH-12;42MPa
- Left fitting
- 90° light-series flangeOriginal Chinese: 90°法兰-轻型
- Right fitting
- 90° light-series flangeOriginal Chinese: 90°法兰-轻型
Workshop guide
Finding the correct hydraulic hose for Doosan DX225LCA Swing Motor
Start with the machine and route
For Doosan DX225LCA Swing Motor, identify the exact model and hydraulic system on the machine first. A part number or diagram pipe number is the fastest way to narrow a replacement hose; if neither is visible, compare the installation route and the existing hose.
Read the dimensions before cutting
Check whether a listed dimension is finished assembly length, hose-only length, or cut length. These are not interchangeable. Confirm hose specification and pressure rating, then compare both ends separately: thread, sealing seat, size, angle, and orientation.
Records to compare
- 2184-1036D43550 mm · DN13;1SN-08;16MPa · 回转马达 · SWING MOTOR · Fig. 1190 · 管号 1K
Use the drawing as a location check
Where an installation drawing or manual figure is available, match its callout to the part number and physical route. A hydraulic circuit diagram explains connections but does not show the exact routing of a hose on the machine. Take the old hose or clear end-fitting photographs to the workshop if any dimension is missing.
For reference only. Confirm the actual hose before fabrication.