- Length
- 710 mm
- Specification
- DN12;2SN-8;27.5MPa
- Left fitting
- 90° elbow, American female thread, flat-face sealOriginal Chinese: 90°美制内螺纹平面密封
- Right fitting
- 90° elbow, American female thread, flat-face sealOriginal Chinese: 90°美制内螺纹平面密封
Individual hose record
4389466 Hose Repair Specifications
Excavator · Hitachi · EX80-5 · Control Valve
Finished length680 mm
Repair specifications
- Part number
- 4389466
- Diagram pipe number
- 8
- Installation route
- 分配阀左下~回转马达
- Hose specification
- DN12;2SN-8;27.5MPa
- Finished length
- 680 mm
- Working pressure
- 27.5 MPa
- Left fitting
- 90° elbow, American female thread, flat-face sealOriginal Chinese: 90°美制内螺纹平面密封
- Right fitting
- 90° elbow, American female thread, flat-face sealOriginal Chinese: 90°美制内螺纹平面密封
- Quantity
- 1
Same system
Related Hoses
- Length
- 950 mm
- Specification
- DN10;2SN-6;28Mpa
- Left fitting
- 美制内螺纹37°内锥
- Right fitting
- 90°美制内螺纹37°内锥
- Length
- 380 mm
- Specification
- DN6;1SN-4;7Mpa
- Left fitting
- 90°美制内螺纹37°内锥
- Right fitting
- 90°美制内螺纹37°内锥
Workshop guide
Finding the correct hydraulic hose for Hitachi EX80-5 Control Valve
Start with the machine and route
For Hitachi EX80-5 Control Valve, identify the exact model and hydraulic system on the machine first. A part number or diagram pipe number is the fastest way to narrow a replacement hose; if neither is visible, compare the installation route and the existing hose.
Read the dimensions before cutting
Check whether a listed dimension is finished assembly length, hose-only length, or cut length. These are not interchangeable. Confirm hose specification and pressure rating, then compare both ends separately: thread, sealing seat, size, angle, and orientation.
Records to compare
- 4389466680 mm · DN12;2SN-8;27.5MPa · 分配阀左下~回转马达
Use the drawing as a location check
Where an installation drawing or manual figure is available, match its callout to the part number and physical route. A hydraulic circuit diagram explains connections but does not show the exact routing of a hose on the machine. Take the old hose or clear end-fitting photographs to the workshop if any dimension is missing.
For reference only. Confirm the actual hose before fabrication.