Individual hose record
Excavator · Hitachi · ZX120-3 · Control Lever
Hose repair card
Hitachi ZX120-3Pipe No. 12 · Part 4686094
Left fitting美制内螺纹37°内锥JIC 37° · 0°View real fitting photos ↗
Right fitting90°美制内螺纹37°内锥JIC 37° · 90°View real fitting photos ↗
Route模式转换阀~中转接头
Tap the card to enlarge it without leaving this page.
Same system
Workshop guide
For Hitachi ZX120-3 Control Lever, identify the exact model and hydraulic system on the machine first. A part number or diagram pipe number is the fastest way to narrow a replacement hose; if neither is visible, compare the installation route and the existing hose.
Check whether a listed dimension is finished assembly length, hose-only length, or cut length. These are not interchangeable. Confirm hose specification and pressure rating, then compare both ends separately: thread, sealing seat, size, angle, and orientation.
Where an installation drawing or manual figure is available, match its callout to the part number and physical route. A hydraulic circuit diagram explains connections but does not show the exact routing of a hose on the machine. Take the old hose or clear end-fitting photographs to the workshop if any dimension is missing.
For reference only. Confirm the actual hose before fabrication.
