Make this hose124-1260
Finished length2,100 mm
Hose specification13II
Quantity1
Left fitting13/16″ 0°（手写接头规格）FITTING · 0°View real fitting photos ↗
Right fitting13/16″ 90°（手写接头规格）FITTING · 90°View real fitting photos ↗
Route滤芯—电磁阀
Individual hose record
124-1260 Hose Repair Specifications
Excavator · Caterpillar · CAT®345D L · Solenoid Valve
Finished length2,100 mm
Hose repair card
Everything needed to identify and make this hose
Caterpillar CAT®345D LPart 124-1260
Tap the card to enlarge it without leaving this page.
Repair specifications
- Part number
- 124-1260
- Installation route
- 滤芯—电磁阀
- Hose specification
- 13II
- Finished length
- 2,100 mm
- Left fitting
- 13/16″ 0°（手写接头规格）
- Right fitting
- 13/16″ 90°（手写接头规格）
- Quantity
- 1
Workshop guide
Finding the correct hydraulic hose for Caterpillar CAT®345D L Solenoid Valve
Start with the machine and route
For Caterpillar CAT®345D L Solenoid Valve, identify the exact model and hydraulic system on the machine first. A part number or diagram pipe number is the fastest way to narrow a replacement hose; if neither is visible, compare the installation route and the existing hose.
Read the dimensions before cutting
Check whether a listed dimension is finished assembly length, hose-only length, or cut length. These are not interchangeable. Confirm hose specification and pressure rating, then compare both ends separately: thread, sealing seat, size, angle, and orientation.
Records to compare
- 124-12602,100 mm · 13II · 滤芯—电磁阀
Use the drawing as a location check
Where an installation drawing or manual figure is available, match its callout to the part number and physical route. A hydraulic circuit diagram explains connections but does not show the exact routing of a hose on the machine. Take the old hose or clear end-fitting photographs to the workshop if any dimension is missing.
For reference only. Confirm the actual hose before fabrication.