Make this hose20Y-62-52690
Finished length1,000 mm
Hose specification25IV
Quantity1
Left fittingF44 0°FITTING · 0°View real fitting photos ↗
Right fittingF44 90°FITTING · 0°View real fitting photos ↗
Route液压泵—分配阀上边
Individual hose record
20Y-62-52690 Hose Repair Specifications
Excavator · Komatsu · PC200-8M0 · Hydraulic Pump
Finished length1,000 mm
Hose repair card
Everything needed to identify and make this hose
Komatsu PC200-8M0Part 20Y-62-52690
Tap the card to enlarge it without leaving this page.
Repair specifications
- Part number
- 20Y-62-52690
- Installation route
- 液压泵—分配阀上边
- Hose specification
- 25IV
- Finished length
- 1,000 mm
- Left fitting
- F44 0°
- Right fitting
- F44 90°
- Quantity
- 1
Workshop guide
Finding the correct hydraulic hose for Komatsu PC200-8M0 Hydraulic Pump
Start with the machine and route
For Komatsu PC200-8M0 Hydraulic Pump, identify the exact model and hydraulic system on the machine first. A part number or diagram pipe number is the fastest way to narrow a replacement hose; if neither is visible, compare the installation route and the existing hose.
Read the dimensions before cutting
Check whether a listed dimension is finished assembly length, hose-only length, or cut length. These are not interchangeable. Confirm hose specification and pressure rating, then compare both ends separately: thread, sealing seat, size, angle, and orientation.
Records to compare
- 20Y-62-526901,000 mm · 25IV · 液压泵—分配阀上边
Use the drawing as a location check
Where an installation drawing or manual figure is available, match its callout to the part number and physical route. A hydraulic circuit diagram explains connections but does not show the exact routing of a hose on the machine. Take the old hose or clear end-fitting photographs to the workshop if any dimension is missing.
For reference only. Confirm the actual hose before fabrication.