Make this hoseP920-122010
Finished length500 mm
Hose specification19I
Quantity1
Left fitting13/16 0°FITTING · 0°View real fitting photos ↗
Right fitting13/16 45°FITTING · 0°View real fitting photos ↗
Route先导泵—回油铁管
Individual hose record
P920-122010 Hose Repair Specifications
Excavator · Hyundai · R215-9 · 先导泵回油回路
Finished length500 mm
Hose repair card
Everything needed to identify and make this hose
Hyundai R215-9Part P920-122010
Tap the card to enlarge it without leaving this page.
Repair specifications
- Part number
- P920-122010
- Installation route
- 先导泵—回油铁管
- Hose specification
- 19I
- Finished length
- 500 mm
- Left fitting
- 13/16 0°
- Right fitting
- 13/16 45°
- Quantity
- 1
Workshop guide
Finding the correct hydraulic hose for Hyundai R215-9 先导泵回油回路
Start with the machine and route
For Hyundai R215-9 先导泵回油回路, identify the exact model and hydraulic system on the machine first. A part number or diagram pipe number is the fastest way to narrow a replacement hose; if neither is visible, compare the installation route and the existing hose.
Read the dimensions before cutting
Check whether a listed dimension is finished assembly length, hose-only length, or cut length. These are not interchangeable. Confirm hose specification and pressure rating, then compare both ends separately: thread, sealing seat, size, angle, and orientation.
Records to compare
- P920-122010500 mm · 19I · 先导泵—回油铁管
Use the drawing as a location check
Where an installation drawing or manual figure is available, match its callout to the part number and physical route. A hydraulic circuit diagram explains connections but does not show the exact routing of a hose on the machine. Take the old hose or clear end-fitting photographs to the workshop if any dimension is missing.
For reference only. Confirm the actual hose before fabrication.