Make this hoseC184-00004
Finished length310 mm
Hose specification6I
Quantity1
Left fitting1/4″ D型 0°（手写接头规格）FITTING · 0°View real fitting photos ↗
Right fitting1/4″ D型 90°（手写接头规格）FITTING · 90°View real fitting photos ↗
Route中心油道—回转马达
Individual hose record
C184-00004 Hose Repair Specifications
Excavator · Doosan · DH55GOLD · 回转系统
Finished length310 mm
Hose repair card
Everything needed to identify and make this hose
Doosan DH55GOLDPart C184-00004
Tap the card to enlarge it without leaving this page.
Repair specifications
- Part number
- C184-00004
- Installation route
- 中心油道—回转马达
- Hose specification
- 6I
- Finished length
- 310 mm
- Left fitting
- 1/4″ D型 0°（手写接头规格）
- Right fitting
- 1/4″ D型 90°（手写接头规格）
- Quantity
- 1
Workshop guide
Finding the correct hydraulic hose for Doosan DH55GOLD 回转系统
Start with the machine and route
For Doosan DH55GOLD 回转系统, identify the exact model and hydraulic system on the machine first. A part number or diagram pipe number is the fastest way to narrow a replacement hose; if neither is visible, compare the installation route and the existing hose.
Read the dimensions before cutting
Check whether a listed dimension is finished assembly length, hose-only length, or cut length. These are not interchangeable. Confirm hose specification and pressure rating, then compare both ends separately: thread, sealing seat, size, angle, and orientation.
Records to compare
- C184-00004310 mm · 6I · 中心油道—回转马达
Use the drawing as a location check
Where an installation drawing or manual figure is available, match its callout to the part number and physical route. A hydraulic circuit diagram explains connections but does not show the exact routing of a hose on the machine. Take the old hose or clear end-fitting photographs to the workshop if any dimension is missing.
For reference only. Confirm the actual hose before fabrication.