- Length
- 520 mm
- Specification
- DN13;1SN-8;10.4Mpa
- Left fitting
- 90° elbow, American female thread, flat-face sealOriginal Chinese: 90°美制内螺纹平面密封
- Right fitting
- American female thread, flat-face sealOriginal Chinese: 美制内螺纹平面密封
Individual hose record
354-4518 Hose Repair Specifications
Excavator · Caterpillar · CAT®312E L · Hydraulic Tank
Finished length970 mm
Repair specifications
- Part number
- 354-4518
- Diagram pipe number
- 47
- Installation route
- 液压油箱~蓄能器电磁阀(液压泵后下)
- Hose specification
- DN13;1SN-8;10.4Mpa
- Finished length
- 970 mm
- Working pressure
- 10.4 MPa
- Left fitting
- American female thread, flat-face sealOriginal Chinese: 美制内螺纹平面密封
- Right fitting
- 90° elbow, American female thread, flat-face sealOriginal Chinese: 90°美制内螺纹平面密封
- Quantity
- 1
Same system
Related Hoses
- Length
- 482 mm
- Specification
- DN19;1SN-12;8.7Mpa
- Left fitting
- 90° elbow, American female thread, flat-face sealOriginal Chinese: 90°美制内螺纹平面密封
- Right fitting
- American female thread, flat-face sealOriginal Chinese: 美制内螺纹平面密封
Workshop guide
Finding the correct hydraulic hose for Caterpillar CAT®312E L Hydraulic Tank
Start with the machine and route
For Caterpillar CAT®312E L Hydraulic Tank, identify the exact model and hydraulic system on the machine first. A part number or diagram pipe number is the fastest way to narrow a replacement hose; if neither is visible, compare the installation route and the existing hose.
Read the dimensions before cutting
Check whether a listed dimension is finished assembly length, hose-only length, or cut length. These are not interchangeable. Confirm hose specification and pressure rating, then compare both ends separately: thread, sealing seat, size, angle, and orientation.
Records to compare
- 354-4518970 mm · DN13;1SN-8;10.4Mpa · 液压油箱~蓄能器电磁阀(液压泵后下)
Use the drawing as a location check
Where an installation drawing or manual figure is available, match its callout to the part number and physical route. A hydraulic circuit diagram explains connections but does not show the exact routing of a hose on the machine. Take the old hose or clear end-fitting photographs to the workshop if any dimension is missing.
For reference only. Confirm the actual hose before fabrication.