Make this hose4I-3511
Finished length3,350 mm
Hose specification10I
Quantity1
Left fitting11/16 0°（手写接头规格）FITTING · 0°View real fitting photos ↗
Right fitting11/16 0°（手写接头规格）FITTING · 0°View real fitting photos ↗
Route脚踏—分配阀下边
Individual hose record
4I-3511 Hose Repair Specifications
Excavator · Caterpillar · CAT®349D2 · 脚踏控制系统
Finished length3,350 mm
Hose repair card
Everything needed to identify and make this hose
Caterpillar CAT®349D2Part 4I-3511
Tap the card to enlarge it without leaving this page.
Repair specifications
- Part number
- 4I-3511
- Installation route
- 脚踏—分配阀下边
- Hose specification
- 10I
- Finished length
- 3,350 mm
- Left fitting
- 11/16 0°（手写接头规格）
- Right fitting
- 11/16 0°（手写接头规格）
- Quantity
- 1
Workshop guide
Finding the correct hydraulic hose for Caterpillar CAT®349D2 脚踏控制系统
Start with the machine and route
For Caterpillar CAT®349D2 脚踏控制系统, identify the exact model and hydraulic system on the machine first. A part number or diagram pipe number is the fastest way to narrow a replacement hose; if neither is visible, compare the installation route and the existing hose.
Read the dimensions before cutting
Check whether a listed dimension is finished assembly length, hose-only length, or cut length. These are not interchangeable. Confirm hose specification and pressure rating, then compare both ends separately: thread, sealing seat, size, angle, and orientation.
Records to compare
- 4I-35113,350 mm · 10I · 脚踏—分配阀下边
Use the drawing as a location check
Where an installation drawing or manual figure is available, match its callout to the part number and physical route. A hydraulic circuit diagram explains connections but does not show the exact routing of a hose on the machine. Take the old hose or clear end-fitting photographs to the workshop if any dimension is missing.
For reference only. Confirm the actual hose before fabrication.