Individual hose record
Excavator · Caterpillar · CAT®318F L · Control Lever
Hose repair card
Caterpillar CAT®318F LPipe No. 1 · Part 4I-0833
Left fittingAmerican female thread, flat-face sealFITTING · 0°View real fitting photos ↗
Right fitting90° elbow, American female thread, flat-face sealFITTING · 90°View real fitting photos ↗
Route中转接头~分配阀下
Tap the card to enlarge it without leaving this page.
Same system
Diagram Pipe No. 2
Installation route: Intermediate adapter → control valveOriginal Chinese: 中转接头~分配阀
Workshop guide
For Caterpillar CAT®318F L Control Lever, identify the exact model and hydraulic system on the machine first. A part number or diagram pipe number is the fastest way to narrow a replacement hose; if neither is visible, compare the installation route and the existing hose.
Check whether a listed dimension is finished assembly length, hose-only length, or cut length. These are not interchangeable. Confirm hose specification and pressure rating, then compare both ends separately: thread, sealing seat, size, angle, and orientation.
Where an installation drawing or manual figure is available, match its callout to the part number and physical route. A hydraulic circuit diagram explains connections but does not show the exact routing of a hose on the machine. Take the old hose or clear end-fitting photographs to the workshop if any dimension is missing.
For reference only. Confirm the actual hose before fabrication.
