Make this hoseDS2040329
Finished length880 mm
Hose specification25IV
Quantity1
Left fittingF47.6 0°（手写接头规格）FITTING · 0°View real fitting photos ↗
Right fittingF47.6 90°（手写接头规格）FITTING · 0°View real fitting photos ↗
Route回转马达—分配阀（里边）
Individual hose record
DS2040329 Hose Repair Specifications
Excavator · Doosan · DH420LC-7 · Swing Motor
Finished length880 mm
Hose repair card
Everything needed to identify and make this hose
Doosan DH420LC-7Part DS2040329
Tap the card to enlarge it without leaving this page.
Repair specifications
- Part number
- DS2040329
- Installation route
- 回转马达—分配阀（里边）
- Hose specification
- 25IV
- Finished length
- 880 mm
- Left fitting
- F47.6 0°（手写接头规格）
- Right fitting
- F47.6 90°（手写接头规格）
- Quantity
- 1
Workshop guide
Finding the correct hydraulic hose for Doosan DH420LC-7 Swing Motor
Start with the machine and route
For Doosan DH420LC-7 Swing Motor, identify the exact model and hydraulic system on the machine first. A part number or diagram pipe number is the fastest way to narrow a replacement hose; if neither is visible, compare the installation route and the existing hose.
Read the dimensions before cutting
Check whether a listed dimension is finished assembly length, hose-only length, or cut length. These are not interchangeable. Confirm hose specification and pressure rating, then compare both ends separately: thread, sealing seat, size, angle, and orientation.
Records to compare
- DS2040329880 mm · 25IV · 回转马达—分配阀（里边）
Use the drawing as a location check
Where an installation drawing or manual figure is available, match its callout to the part number and physical route. A hydraulic circuit diagram explains connections but does not show the exact routing of a hose on the machine. Take the old hose or clear end-fitting photographs to the workshop if any dimension is missing.
For reference only. Confirm the actual hose before fabrication.