Make this hoseDS2011284
Finished length660 mm
Hose specification25I（手写管线代码）
Quantity1
Left fitting1 7/16″ A型 0°（手写接头规格）FITTING · 0°View real fitting photos ↗
Right fitting1 7/16″ A型 0°（手写接头规格）FITTING · 0°View real fitting photos ↗
Route回转马达~分配阀（回油）
Individual hose record
DS2011284 Hose Repair Specifications
Excavator · Doosan · DX380LC · Swing Motor
Finished length660 mm
Hose repair card
Everything needed to identify and make this hose
Doosan DX380LCPart DS2011284
Tap the card to enlarge it without leaving this page.
Repair specifications
- Part number
- DS2011284
- Installation route
- 回转马达~分配阀（回油）
- Hose specification
- 25I（手写管线代码）
- Finished length
- 660 mm
- Left fitting
- 1 7/16″ A型 0°（手写接头规格）
- Right fitting
- 1 7/16″ A型 0°（手写接头规格）
- Quantity
- 1
Workshop guide
Finding the correct hydraulic hose for Doosan DX380LC Swing Motor
Start with the machine and route
For Doosan DX380LC Swing Motor, identify the exact model and hydraulic system on the machine first. A part number or diagram pipe number is the fastest way to narrow a replacement hose; if neither is visible, compare the installation route and the existing hose.
Read the dimensions before cutting
Check whether a listed dimension is finished assembly length, hose-only length, or cut length. These are not interchangeable. Confirm hose specification and pressure rating, then compare both ends separately: thread, sealing seat, size, angle, and orientation.
Records to compare
- DS2011284660 mm · 25I（手写管线代码） · 回转马达~分配阀（回油）
Use the drawing as a location check
Where an installation drawing or manual figure is available, match its callout to the part number and physical route. A hydraulic circuit diagram explains connections but does not show the exact routing of a hose on the machine. Take the old hose or clear end-fitting photographs to the workshop if any dimension is missing.
For reference only. Confirm the actual hose before fabrication.