Make this hose60157572
Finished length900 mm
Hose specification19IV
Quantity1
Left fittingF38.1 0°FITTING · 0°View real fitting photos ↗
Right fittingF47.6 45°FITTING · 0°View real fitting photos ↗
Route回转马达—分配阀前边
Individual hose record
60157572 Hose Repair Specifications
Excavator · SANY · SY365CD-I3K · Swing Motor
Finished length900 mm
Hose repair card
Everything needed to identify and make this hose
SANY SY365CD-I3KPart 60157572
Tap the card to enlarge it without leaving this page.
Repair specifications
- Part number
- 60157572
- Installation route
- 回转马达—分配阀前边
- Hose specification
- 19IV
- Finished length
- 900 mm
- Left fitting
- F38.1 0°
- Right fitting
- F47.6 45°
- Quantity
- 1
Workshop guide
Finding the correct hydraulic hose for SANY SY365CD-I3K Swing Motor
Start with the machine and route
For SANY SY365CD-I3K Swing Motor, identify the exact model and hydraulic system on the machine first. A part number or diagram pipe number is the fastest way to narrow a replacement hose; if neither is visible, compare the installation route and the existing hose.
Read the dimensions before cutting
Check whether a listed dimension is finished assembly length, hose-only length, or cut length. These are not interchangeable. Confirm hose specification and pressure rating, then compare both ends separately: thread, sealing seat, size, angle, and orientation.
Records to compare
- 60157572900 mm · 19IV · 回转马达—分配阀前边
Use the drawing as a location check
Where an installation drawing or manual figure is available, match its callout to the part number and physical route. A hydraulic circuit diagram explains connections but does not show the exact routing of a hose on the machine. Take the old hose or clear end-fitting photographs to the workshop if any dimension is missing.
For reference only. Confirm the actual hose before fabrication.